| 1. | Place motor assembly (E) between the hinge brackets on the frame assembly and insert hinge pin (F) all the way through. Put drive belt (G) on both pulleys making sure they are lined up. Adjust drive belt for a minimum of � inch play. Adjust using 9/16 inch wrench. |
| 2. | Plug motor into switch box. Square plug at rear of motor must have red marks lined up. To reverse this plug will change rotation of motor. |
| 3. | Insert table legs into the corner slots of the tabletop. Bolt with eight � inch bolts (2 per leg) with flat washers, lock washers and nuts. |
| 4. | Position guard bracket (L) as shown and fasten with two � inch bolts with flat washers. |
| 5. | Attach hanger brackets (N) using five � inch bolts and washers. |
| 6. | Position front guard (M) from underneath (top side of table top) into the guard bracket (L) as shown and attach with two � inch nuts, flat washers and lock washers and tighten in place. |
| 7. | Attach leaf bracket (C) using two � inch bolts, nuts, washers, and lock washers. |
| 8. | Attach table leaf (B) using four � inch bolts, nuts, washers, and lock washers. |
| 9. | Turn over the K102 Wreath Machine onto its legs. It will take two people, one on each side. |
| 10. | Check table legs for unused holes 2 inches above floor. Machines made after 1995 have holes. Those made before 1995 have no holes. |
| 11. | If your table has no holes, drill two 3/8 inch holes - one in the side of each rear leg. These holes should be 2 inches above the floor and in the center of each leg. |
| 12. | Slide the foot lever tube through the hole in the rear of the foot lever; center this tube and tighten the clamp bolt. |
| 13. | Slide the foot lever attachment rod through the tube and both rear legs. Place a washer and nut on each side and secure so that it is not too tight. |
| 14. | Attach and adjust chain or arm through slot in center of foot lever arm using bolt included. |
| 15. | Replace the adjustable guide wheel (P) (removed in step 3) by sliding it down the post until the rubber guide wheel fits gently into the groove on the main wheel. Do not adjust it too tight! Secure the guide wheel in position by tightening the two set bolts. |
| 16. | Plug the main power cord (not shown) into any grounded 110 volt outlet and the K102 Wreath Machine is ready to operate. Do not use a three prong plug adapter! If an extension cord is used, be sure it is a heavy duty one of at least 12 gauge wire. |
| 1. | Fasten garland attachment through three holes in table. Please note that the garland attachment is shipped with the garland-steadying pin not in place. Install by sliding pin through opening beneath twine guide. |
| 2. | Point of garland steadying pin should extend approximately 1" (one inch) over the table top for most garland material. |
| 3. | Garland using short greens, (which is advanced slowly) adjust the pin back ½". |
| 4. | Garland using long greens, (i.e.; cedar, laurel, etc.) adjust the pin forward ½" to 1 inch. |
| 5. | Thread twine core through attachment, set a light tension. |
